Froggy Jumps 5.9 Storage and RAID TroubleshootingOnline version testout by Mr. B 1 While trying to start Windows , you see the following error message: Could not read from the selected boot disk. What will fix problem? a Boot into Safe Mode and restore to a restore point b Boot into the recovery console and copy the NTLDR file to the boot volume. c Boot into the recovery environment and run the bootrec /rebuildbcd command. 2 Lately, you hear a clicking noise when reading or writing data from the hard disk.What is the MOST likely cause of the clicking? a Overheated CPU b Failing hard drive c Failed UPS 3 The SMART hard disk check has detected an imminent failure. Which of the following is the best FIRST step to take? a Back up all important data and files. b Correct the bad areas on the drive using chkdsk. c Run a hard drive test to verify the hard disk's condition. 4 Which of the following can you do to disable defragmentation in Windows? a Select Optimize from the Optimize Drive dialo b Open Device Manager, right-click the SSD drive c Select Change Settings from the Optimize Drive dialog. Then clear the Run on a schedule option. 5 You upgraded a 250 to a 450-watt power supply. Now the BIOS does not recognize one of the hard disk drives in the system during POST. What steps is the BEST to try first a Manually enter the hard disk geometry parameters in the BIOS. b Make sure that the hard disk is connected to the power supply. c Replace the power supply.
New game